Jump to content


Cutting Out Wheel Wells Perfect Every Time!


  • You cannot reply to this topic
1 reply to this topic

#1 hooknladderno1

hooknladderno1

    MCM Avid Poster

  • Members
  • PipPipPipPipPip
  • 355 posts
  • Location:Sunny Florida
  • Full Name:David Gusky

Posted 06 December 2012 - 10:05 PM

Hi Guys,

Have you ever wondered how some modelers make such "PERFECT"  wheel wells?  Well, I learned a little secret that can help you achieve success every time.  The OLFA Compass Cutter model CMP-1, is the key:

OLF20CMP-1sd.jpg

It is an inexpensive tool(less than $10 bucks).  It adjust to a diameter of 6 inches.  It is really easy to use.  Simply mark out the center point of where you want your wheels to be.  Lightly press the point or drill a small hole where the compass point will go.  No worries, as this area will be removed once the cuts are made.  Place a small piece of masking tape over the hole.  This will keep the compass from "walking".  Lightly rotate the tool around the diameter of your styrene sheet.  With each pass, go a little deeper.  Soon, your plastic disc will be free.  You can use this technique on single wheel wells:

picsay-1319923137.jpg

or doubles:

picsay-1325430533.jpg

You can order the tool directly from OLFA, or purchase it locally from craft or hobby shops.  Replacement blades are also available.  Hope you find this useful.



#2 kilrathy10

kilrathy10

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 1,690 posts
  • Location:Spring, Tx.
  • Full Name:JT Williams

Posted 07 December 2012 - 09:42 AM

I have one of these...Haven't tried it, yet...Do you have any pics of how you've used it...