Jump to content


337 ford engine


  • You cannot reply to this topic
5 replies to this topic

#1 Frank

Frank

    MCM Friend

  • Members
  • PipPipPipPip
  • 241 posts
  • Location:Australia

Posted 24 January 2013 - 06:11 PM

What happened to Dencon Resin is he coming back.

 

Can anyone tell me where I can get a Dencon Ford 337 Flathead "Rouge" Engine, please.


Edited by Frank, 13 February 2013 - 07:25 PM.


#2 Casey

Casey

    MCM Ohana

  • Moderator
  • PipPipPipPipPipPip
  • 8,309 posts
  • Location:Milwaukee, WI
  • Full Name:Casey Littmann

Posted 14 February 2013 - 06:13 AM

You'll probably have to wait for one to pop up on eBay, Frank, or put an ad in the Wanted section here.



#3 dimaxion

dimaxion

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 1,019 posts
  • Location:NE Indiana
  • Full Name:John JR. Landgraver

Posted 14 February 2013 - 06:46 AM

I did contact Matt here on this site . = no answer ? Thanx ..

#4 Ken Kitchen

Ken Kitchen

    MCM Friend

  • Members
  • PipPipPipPip
  • 100 posts
  • Location:Colorado Springs, CO

Posted 14 February 2013 - 02:00 PM

What happened to Dencon Resin is he coming back.

 

Can anyone tell me where I can get a Dencon Ford 337 Flathead "Rouge" Engine, please.

Is this the Flathead V8 that was in the big trucks and Lincolns? If so I might be able to help. Contact me at kitchen_table_resins@yahoo.com



#5 Eshaver

Eshaver

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 3,871 posts
  • Location:Richmond Virginia for now
  • Full Name:Ed Shaver

Posted 16 February 2013 - 10:26 AM

Is this the Flathead V8 that was in the big trucks and Lincolns? If so I might be able to help. Contact me at kitchen_table_resins@yahoo.com


Yes ken, that's the Ford "Big Job " engine .

#6 Ken Kitchen

Ken Kitchen

    MCM Friend

  • Members
  • PipPipPipPip
  • 100 posts
  • Location:Colorado Springs, CO

Posted 16 February 2013 - 11:02 AM

Yes ken, that's the Ford "Big Job " engine .

Ed,

 

Thanks for the reply. Matt and I by purest of coincidence both produced a master of this engine at nearly the same time.  Since he was first out of the gate I didn't push mine. But if he's no longer producing them I would consider offering mine again.

 

Ken