Jump to content


pete3522

Member Since 27 Nov 2010
Offline Last Active Yesterday, 05:11 AM
-----

Posts I've Made

In Topic: 55 ton 3-axle lowboy

09 February 2015 - 04:31 PM

Definitely a good start to show how to build your own ! A little plasticstruct  and some patience!


In Topic: Peterbilt 359 from AMT kit

09 January 2015 - 06:01 PM

Heres one I did note the hinges on the bottom of the hood


In Topic: Peterbilt 359 from AMT kit

09 January 2015 - 05:56 PM

I built a few of these and made the hood tilt. Cut the tab off the bottom of the grille . Take some styrene or some scrap plastic pieces drill a couple small holes 2 pieces one on each side of the backside of the grille. either drill the front of the frame rails or 2 more drilled pieces one on each side glued to the frame rails and you now have a tilt hood! I use a nail or a piece of wire to go thru the holes


In Topic: What cool trucks (rigs or pick ups) have you seen lately?

06 January 2015 - 08:13 AM

Heres some different ones I have come across over the years