Jump to content


Member Since 26 May 2011
Offline Last Active Yesterday, 09:19 AM

Posts I've Made

In Topic: Embossing Powder

12 March 2015 - 05:30 AM

You could also try masking the area off and shooting it with a coat of paint / primer / dule coat sealer and then put the embossing powder on. The product is actually used with rubber stamp inks you would put the ink down with a stamp and then put the powder into place and shake off the extra

In Topic: To those that pray...

02 September 2014 - 07:43 AM

Will be praying as well

In Topic: 89 F150

12 May 2014 - 03:54 PM

Which kit was that from I am looking to do an 86 wondered if that could be a starter kit

In Topic: L-700 Coe Trying to run it looooowww

11 May 2014 - 04:57 AM

Hey folks I got a pm about this project thought I would give and update. I have the frame just about done I finished the rear four link setup the front end and have started painting the engine and I am going to try wiring up the viper engine. Model time is limited with work and other things. I will try and post some updated photos

In Topic: AEC ROUTEMASTER RLM double-decker bus

10 May 2014 - 10:14 AM

Just e-mailed with the Czech guys will be placing an order soon