Jump to content


HOLMES55

Member Since 12 Jul 2011
Offline Last Active Yesterday, 05:15 AM
-----

Topics I've Started

Painting torque thrust rims

10 June 2014 - 08:29 AM

I have these chrome torque thrust rims from the 1968 Bullit mustang kit that I wanted to paint the spokes gray for the magnesium look.

I have seen other models with spokes painted and wanted to know other peoples technique to paint their rims. I prefer masking tape

and spray paint but it seems like it might be easier to brush paint them. When I brush paint sometimes you can see the brush marks.

Attached File  Torque Thrust2.jpg   17.44KB   2 downloads

Attached File  Torque Thrust1.jpg   31.4KB   2 downloads


1941 willys Pickup

05 May 2014 - 07:32 AM

Here is the kit I started with

Attached File  41w7118r.jpg   55.42KB   3 downloads

The front end was too low and the wheels sat back to far. I raised the front end and moved the wheels forward.

The rear differential was mounted to quarter elliptical springs and did not look sturdy enough so I replaced them

with leaf springs.

I took a lot of the chrome off and used model masters metalizer paints. This was the first time I have used them

and noticed if you put primer under them they didn't buff out much and work better spraying over the bare plastic.

Here is the motor/chassis:

Attached File  100_4231.JPG   87.78KB   1 downloadsAttached File  100_4233.JPG   96.75KB   0 downloadsAttached File  100_4234.JPG   97.54KB   0 downloads

I did get the doors to line up fairly well

Attached File  100_4238.JPG   98.62KB   0 downloadsAttached File  100_4239.JPG   117.05KB   0 downloads

The tires are 2 piece type but I used them anyway

Attached File  100_4250.JPG   86.76KB   0 downloadsAttached File  100_4241.JPG   95.69KB   0 downloads

Attached File  100_4242.JPG   81.46KB   0 downloadsAttached File  100_4243.JPG   86.69KB   0 downloads

Attached File  100_4244.JPG   92.17KB   0 downloadsAttached File  100_4246.JPG   92.17KB   0 downloads