Jump to content


Sparky68

Member Since 20 Jul 2011
Offline Last Active Nov 27 2011 07:03 AM
-----

Posts I've Made

In Topic: 1966 Chevelle Wagon ProStreet Custom

02 October 2011 - 06:36 AM

SWEET! Looking good!!!

In Topic: '55 Chevy P/S

29 September 2011 - 12:59 PM

I found the v.c.'s that go with the heads and finished the runners(cut them down).
Posted Image
Posted Image

In Topic: '55 Chevy P/S

19 September 2011 - 10:30 AM

Well I might add aluminum tube to the tunnel ram setup. You think it's to high(tubes to long)? I also sandwich a piece of styrene scrap between the top/base and the bottom. It has a more real look to it now then before(sat to low).
Posted Image
Posted Image
I started to cut up a carb(split carb setup maybe?). There's 2 different carbs in the pic. The cutup carb is a MCG(model car garage) the other one(don't know, parts bin)
Posted Image

In Topic: '55 Chevy P/S

14 September 2011 - 12:09 PM

Thanks Tim(aka;nybuilder) I used .100" rod & .080" rod for some of the inter tin chassis work. Well think I'm gonna use thiss motor. It's a bbc that I took and glued then cut up into 1/4's and pieced back making it wider and tall with stryene sheet after all that casted her. All the other parts are from part bins. Still not sure about the carb setup looking more towards a blower setup instead.
Posted Image
Posted Image

In Topic: '55 Chevy P/S

12 September 2011 - 02:23 PM

Looking beefy and great, keep it going.


Thanks! I keep putting this model down and walking away and working on something else, but it keeps calling me back with I new idea.