cobramike Posted May 2, 2013 Share Posted May 2, 2013 I have just opened this box and the parts are all molded in grey. My question is has anyone else built this model? If so, will the grey bleed thru primer and paint? I have no intention of using this color...UGH! So if anyone has any thoughts about this let me know. Thanks Quote Link to comment Share on other sites More sharing options...
Jantrix Posted May 2, 2013 Share Posted May 2, 2013 I built this one back in the day molded in grey and had no issues. Quote Link to comment Share on other sites More sharing options...
W-Machine Posted May 2, 2013 Share Posted May 2, 2013 Never had a bleed through with grey plastic. Quote Link to comment Share on other sites More sharing options...
cobramike Posted May 2, 2013 Author Share Posted May 2, 2013 Thanks gents! I didn't think there would be a problem, but thought I would ask because I knew there was folks on here that could answer. Thanks again I am also considering chopping the top, has anyone done that to this? It looks pretty straight forward. I can't believe how thin the plastic is, almost to the point of being flimsy. Quote Link to comment Share on other sites More sharing options...
Guest G Holding Posted May 4, 2013 Share Posted May 4, 2013 (edited) I use a lot of grey primers, so I don't think there is anything to worry about. As far as chopping goes, this one is not too bad, you will need to cut the top into 4 parts or 6 depending on how the posts line up. Not much different than a sedan. Heres a good hot rodding "primer" http://www.modelcarsmag.com/forums/index.php?showtopic=517&st Edited May 4, 2013 by G Holding Quote Link to comment Share on other sites More sharing options...
Ace-Garageguy Posted May 4, 2013 Share Posted May 4, 2013 I am also considering chopping the top, has anyone done that to this? It looks pretty straight forward. I can't believe how thin the plastic is, almost to the point of being flimsy. The easiest way to chop a '32 closed car is to keep the B-pillars lined up and bring the roof straight down, while slightly leaning the A-pillars (windshield pillars) BACK to correct the alignment, and slightly reworking / filling the mis-alignment of the C-pillars. Though this is a '32 coupe, if you take about 3.5 scale inches out of the Vicky, your pillars will end up with about this much mis-alignment. You can see that a gentle tweeking of the windshield pillars will correct the alignment without having to resort to cutting the roof into sections, and reshaping of the rear quarter pillars will accomplish the same thing on that end. Again, bring the B-pillars STRAIGHT DOWN, and reshape the front and rears. The Vicky will be a little worse at the rear than this coupe, but not too horribly much. I just looked at a '32 Vicky body of my own to verify this. Quote Link to comment Share on other sites More sharing options...
935k3 Posted May 4, 2013 Share Posted May 4, 2013 I did have a problem with gray plastic. Revell of Germany Mercedes DTM car had the main body in grey and the running bord/lower sills molded in white. When they were primed using Plastikote T235 sandable white primer there was a noticeable difference in the parts. I sprayed some BIN sealer and more primer to correct and it came out perfectly matched. BIN sealer is excellent for this but it is better airbrushed because the cans spray terribly. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.