Robert Myers

Actually, I have one. It was made by a resin caster from the southwest United States that filled very few of his orders. He dropped out ouf site back in the 1980s. The cab is thick resin mixed with flour. PRETTY BAD! If the bugs don't eat it, I still hope to build it someday.

Thank you!

I use Strip A Kit. You brush it on and let it sit for about 30 minutes, give it a light brushing with a tooth brush and rinse off. I strip and restore a lot of older kits. Some have two or three layers of brush paint. This stuff works every time and has never damaged the plastic. It is thick so you can spot strip small areas and repaint your mistakes. I am not a shill for the company! This stuff is just plain good. You can get it from Hanger 3, POB 361 Arlee MT 59821-0361

I'm new to the forum, but I have been enjoying the plasticcowboy website for years. Tim even posted a couple of my builds. ? is... What color would the engine be in the Marmon COE? I am going for a factory look. The kit is being built on the KW Aero. chassis. Thanks for the help!!!!