bobss396

Very cool build. I use a lot of VCG and Iceman parts. VCG has a couple of QC rears I like. One is make for the Revell 32 kit.

Very good! I have a stalled one I have to get back to. On side pipes, I make up "J" hooks and attach them to the inside of the body or the chassis. I use .010" thick aluminum flashing.

Big time crazy... me like!

I paint outside all year. I step out onto the deck, spray and run back inside. As of late, Duplicolor paints blush no matter what I do. Outside, Tamiya, the old Black Gold line and the Mopar touch up cans are very drama free. In a pinch in really snotty weather. I place a cardboard box (with the front and top sides cut out) on an old snack tray in the finished part of the basement.

I would look at what 3D resin guys like Iceman and VCG Resins have. Also 3dscaleparts. There are others in the 3D vendor forums.

I finally finished up the Pinto. I ran into issues late in 2023 and parked it. I had to do the side rails, put on the headers and make up a lot of radiator parts over the weekend. I'm happy with the way it came out.

I usually skip 1:1 car shows, but do a cruise night with the Ford now and then.

I grab any flat ribbon 🎀 that I see, mostly off gifts. Curling ribbon is good too, run it across a steel scale to take a little texture off it. I fold tabs in the ribbon, put it through the hardware and secure it with CA or tacky glue.

Nice clean builds. I go overboard with mine... too much like work. They are a good starting point though. I am finishing up a Pinto right now. I did the Vega last year.

I like it, nicely executed. I use a lot of Ron's stuff on my cars. How much work was the rear clip to install? I'm considering one for a late model Nova build.

I really like it, nicely done. Everything looks very accurate. They were heavy cars but they could move. Plus larger cars were harder to pass.

Very clean too... nicely done. I have a slew of these kits and similar ones. I never pass up a $3 NASCAR kit. They do build up nicely, I need a break from the Frankenstein builds I'm in the middle of right now.

Interesting, I'm not totally in with no judging however. There is another show on the 18th in Peabody, looks like an IPMS show. I'll have to see if I can dig up some of who vendors will be at the RTS show. Thanks.

We have a local club that meets at a library, for at least 25 years. The time slot is only 2 hours, ours at a community center is 3.

Gofers are not so bad. I have never been successful getting the thick ribbon through the hardware and getting it glued together. I use either paper from other belt kits or ribbon.