59-Desoto Posted August 30, 2010 Share Posted August 30, 2010 (edited) Just wondering has anyone ever built this car or seen it ? The 2Dr. HT version, not the 2dr. sedan. I remember seeing someone post a problem with the body at one time. Kinda wanted to buy it if the problem wasn't a big deal. But wanted to ask around 1st. Edited August 30, 2010 by 59-Desoto Quote Link to comment Share on other sites More sharing options...
spkgibson Posted September 1, 2010 Share Posted September 1, 2010 I have seen the kit in person,While I was at his shop visiting him,And it can be built into a nice car with some time,I would say go for it and buy one. Quote Link to comment Share on other sites More sharing options...
59-Desoto Posted September 3, 2010 Author Share Posted September 3, 2010 I have seen the kit in person,While I was at his shop visiting him,And it can be built into a nice car with some time,I would say go for it and buy one. Good deal , thanks Steve . I've been wanting one for a while. I bought couple other from R&R with no issues but some where in the back of my mine I was thing I had seen a negative post on this one. Going for it and cant wait Quote Link to comment Share on other sites More sharing options...
cooltoys1 Posted September 22, 2010 Share Posted September 22, 2010 R&R stuff blows...steer clear Quote Link to comment Share on other sites More sharing options...
BigEdsGarage Posted September 28, 2010 Share Posted September 28, 2010 Hopefully the 65 is a better piece than the 67 Plymouth wagon of theirs I purchased. Quote Link to comment Share on other sites More sharing options...
Chuck Most Posted September 28, 2010 Share Posted September 28, 2010 I probably have more R&R stuff than any other resin product, and I can tell you R&R's casting quality seems to vary quite wildly- I'd say it averages somewhere between 'poor' and 'partly cloudy'. I've built three of the '57 IH pickup kits- the first two were horrible, while the third was actually pretty good- way fewer huge pinholes and thin spots, and much less distortion in the castings. But yeah- I'd avoid an R&R piece for a first-time resin project! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.