FatBoyKuztoms

https://christopherkuhn.smugmug.com/Model-Cars/n-PqfRZX

What size drill bit do I use to make spark plug holes for the spark plug boots?

Got some primer tonight so might be throwing the stang into some primer

Oh believe me my insomnia is not under control lol but I need more glue my CA glue decided to gel up on me.

Oh geez one of my insomnia nights are in full effect. Let's see what I can get done before I pass out.

Any bad points on the kit? (I.e flash, warpage...)

Got more blades for my xacto knife so more cutting to do

Heck I may have to have a pace truck follow me around with extra tires

Actually I do have paper clips, thanks to the dollar store. Here is the passenger door cut out.

So the boys hear in the shop have been working hard. Got a call from the dyno guys, the twin turbo set up has melted the engine, so they went on the hunt around the shop and found an old 426 hemi laying around. So they pulled it out and began to strip it down to begin the rebuild on it.

So the boys hear in the shop have been working hard. Got a call from the dyno guys, the twin turbo set up has melted the engine, so they went on the hunt around the shop and found an old 426 hemi laying around. So they pulled it out and began to strip it down to begin the rebuild on it.

Did some work on this, got the passenger door cut open. Just need to find the rod to make door hinges with. Will post pictures tomorrow

Got sick with this stupid cold so bench time will be slowed down until I start to feel better.

Back to working on this

I have, the trunk I had to putty back shut the window frame was way to loose. So it will be just the doors opening