midengineaddict Posted November 9, 2014 Share Posted November 9, 2014 I have the 1:16 359 Pete and my Project is to stretch the frame and drop the suspension. If someone have picture of how he did that, it will help me a lot... Thanks Quote Link to comment Share on other sites More sharing options...
Newbs99 Posted November 9, 2014 Share Posted November 9, 2014 (edited) Hey man, I am in the process of doing it to the Revel 1:25 359, and to drop it all I did was cut a section(ring) off of the three section(ring) ??dampers??. Not sure how different the 1:16 is, but here is mine...Oh, and for the front, I just trimmed down the axle... The unfinished product... Hope this might help! Edited November 9, 2014 by Newbs99 Quote Link to comment Share on other sites More sharing options...
Petetrucker07 Posted November 9, 2014 Share Posted November 9, 2014 (edited) The front end it would be better, if you have a Dremel, to remove the "axle blocks" and remove a couple leafs from the spring pack. if thats not low enough, cut the spring shakles. If not low enough yet, trim the axle, carefully, doing that will weaken it and cause the axle to sag. Edited November 10, 2014 by Petetrucker07 Quote Link to comment Share on other sites More sharing options...
midengineaddict Posted November 9, 2014 Author Share Posted November 9, 2014 Cool ideas, it will help Quote Link to comment Share on other sites More sharing options...
midengineaddict Posted November 10, 2014 Author Share Posted November 10, 2014 (edited) did someone ever build something like that? Edited November 10, 2014 by midengineaddict Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.