Madd Trucker Posted November 19, 2014 Share Posted November 19, 2014 (edited) I went to slide the fender section over the engine/Radiator and it wont go . Did I miss something or did Revell leave out on removeing the brace between the fenders where the radiator goes. with it in place the fenders wont go down on the frame. any help from any who has built it . Edited November 19, 2014 by Madd Trucker Quote Link to comment Share on other sites More sharing options...
Jim B Posted November 19, 2014 Share Posted November 19, 2014 I had a similar issue with the Revell 1937 Delivery Van (which is basicly the same kit). I got the fenders on just fine as I installed them before I put the radiator in (I think), but I could not get the hood to close properly. It's like the radiator is too wide & too tall. Quote Link to comment Share on other sites More sharing options...
Chuck Most Posted November 19, 2014 Share Posted November 19, 2014 You should be able to slip the brace up under the radiator- if you look there should be a "step" in the radiator to fit it. The only way I could see it not fitting is if you installed the grille shell to the radiator before attaching the fenders. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.