Markemmonsracing Posted December 16, 2012 Share Posted December 16, 2012 Is anyone making a plate system setup or fogger? Quote Link to comment Share on other sites More sharing options...
Fat Brian Posted December 19, 2012 Share Posted December 19, 2012 The plate is so simple to make I don't believe so. Usually the plates are about a half an inch thick or so right? I would just add a piece of sheet plastic to the bottom of whatever carb I'm using, a piece one millimeter thick would represent one scale inch in 1/25, and cut it to match the base plate of the carb. Then just run a wire to it for your NOS line. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.