Jump to content
Model Cars Magazine Forum

patami

Members
  • Posts

    274
  • Joined

  • Last visited

About patami

  • Birthday 02/16/1966

Previous Fields

  • Scale I Build
    1/24,1/25, 1/35

Profile Information

  • Full Name
    Patrik Aminoff

patami's Achievements

MCM Avid Poster

MCM Avid Poster (5/6)

  1. Model (a big one) the gravel in the foregroumd dosent add up whit the rest of the road
  2. That one has been the inspiration for my build actually. I do have and have used the superb Tamiya epoxy puttu and your right its just a fantastic produt. Just wanted to challenge my self and try forming styrene for this one build.
  3. It was an easy one since i saw that one in the Russian M-hobbi mag
  4. The project is stalling. Does any one have a spear 06 Mustang front that they could think of getting rid of? Iv run into front spoiler issue. Cant seem to come up whit anything desent that i would be happy whit. Ideas please
  5. geetee66 thank you for your kind words. I have never pulled of an sucsessfull top chop.
  6. Some times it takes a cuopel oif tryes First try We have our selfs a mustang/challanger No good Second Now wer talking. just have to do it once more in a little thinker styrene
  7. Soo we have been licking that wall have we. Great looking modell
  8. freakshow 12 will do the rears that way too. It ll give the body the right kind of roundness im looking for.
  9. Started on the front fenders. Trying to get a litlle more modern look to the car. Will round of the rear fenders too. Step 1 Did find some metal wheel in my part box. Wrapped the flare to bee around it and gave some heat whit a heardryer Step 2 Then on to a smaller diameter round thing and some heat to it again Step3 Glued in place Step4 Then on whit the outer sheet Done After some trimming almost there. All we need is a fenderflare
  10. DeeCee You start whit a vision and go on from that and hope that you will follow it thru. Iw got an extensive boneyard of stolled project where the vision has died. TFchronos Thank you
×
×
  • Create New...