lwwoodss

Chassis weathering and basic air line plumbing including ride height leveler.

Basis chassis painted. Detail painting on certain components prior to weathering and plumbing.

Chassis finally complete enough for primer and paint . Also current mockup

Working my way down the chassis a few items mounted. Latest mock up.

The hood was hinged today and the cab cowl was removed so that a new one can be built to accommodate the severe service air cleaners on both sides.

Sleeper roof sectioned. Turn out better than I thought. A little seam work to do.

Sectioned the sleeper to 36" and added a rear window. Little seam work to do and still need to section the roof.

Rebuit the chain racks they look much better. Everything is mounted to the deck. Binders added just for the photo.

Built chain racks to go with the chain tray built in to deck and built a hose tender for air and electrical lines.

Built a headache rack/ drom deck today. Latest mock up.

A little progress. Cut the hood so it will open. Added center spine. Cut 1/8 off each side to get rid of the bad edge where the side slats fit and replace with strip stock. Opened the left side for the second air cleaner.

Built cab mounts, some Kenworth crossmembers and some others to hold the rear suspensions. Got part of the 5th wheel built primarily to hold the frame together since nothing is glued. Basis interior is started. All this is enough to get the cab, hood and radiator level. Next is cutting the hood and building hood slats and the cab cowl.

Got the fenders built. Attached the fronts of the fenders to the back of the bumper. Also latest mockup.

Got the front axle on. Metal axle, Italeri spindles and plates, brass tie rod and ujoints. Engine mounts built and engine leveled to fit radiator . Using a Cat 3408. Surprised by the small parts count. It needs some more components. Battery box cleaned up.

Thanks for the response.