Muskiebrains Posted December 16, 2014 Share Posted December 16, 2014 Just a quick mock up I'm stuck on how to slam the front end Quote Link to comment Share on other sites More sharing options...
vintagedragcrazy Posted December 16, 2014 Share Posted December 16, 2014 Cool that's going to pretty bad when your done Vince Quote Link to comment Share on other sites More sharing options...
Truck parts Posted December 16, 2014 Share Posted December 16, 2014 Looking good Quote Link to comment Share on other sites More sharing options...
tubbs Posted December 16, 2014 Share Posted December 16, 2014 Just a quick mock up I'm stuck on how to slam the front endan easy way is to put a small strip of styrene at the bottom of the front air dam to get it "lower". otherwise, you have to move the pin that goes into the front wheel higher on the spindle to drop the front end, then you may have header clearance problems. you could trim a tiny bit off the top of the firewall, or wherever the body makes contact to the chassis. just watch whatever you do, may effect other clearances. Quote Link to comment Share on other sites More sharing options...
Muskiebrains Posted December 16, 2014 Author Share Posted December 16, 2014 Thanks tubbs Quote Link to comment Share on other sites More sharing options...
Muskiebrains Posted December 16, 2014 Author Share Posted December 16, 2014 Decided to cut the springs worked better than expected Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.