mtownsley

I know know what you mean....... I started a charger 500 a while back, but because I was using the revell kit, I was at odds on what to use for a grill. so it sat for a long time. I finally ended up making one........found out it wasnt that tough after all. mark townsley

Bill, I am presently winding up the RM charger, it is an excellent kit. only a few things to watch for. the forward end of the chassis has a small twist. I checked several other kits I had, ...all the same. also check the location of the rear axle in relation to the wheelwell cutouts...depending on tire/wheel selection the spacing may need some attention. as far as front/rear valence panels..... I installed the rear panel before chassis pan , and the front valence after the chassis. I hope to have mine completed in time for kansas city. mark townsley