Jump to content


Fuel Injection Unit For The Ford 300 Big 6 Enigine Kit


  • You cannot reply to this topic
4 replies to this topic

#1 Ken Kitchen

Ken Kitchen

    MCM Friend

  • Members
  • PipPipPipPip
  • 102 posts
  • Location:Colorado Springs, CO

Posted 16 April 2008 - 12:53 PM

Ok here's what I was going for:

Posted Image
Here is the very first pull from the new mold. No cleanup no detail painting just raw resin from the mold.

Posted Image

Posted Image

Posted Image

Posted Image


Well what do you think. Ready for production or back to the drawing board?

Edited by Ken Kitchen, 17 April 2008 - 02:48 AM.


#2 Wildrice

Wildrice

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 1,034 posts
  • Location:Shinnston, West Virginia
  • Full Name:Bobby Boggs

Posted 19 April 2008 - 11:24 AM

Very nice. One question though. Is the valve cover indented? If so the real one is not indented on a Ford 300 six. I work on a lot of them. Just wanted to let you know.

#3 Ken Kitchen

Ken Kitchen

    MCM Friend

  • Members
  • PipPipPipPip
  • 102 posts
  • Location:Colorado Springs, CO

Posted 19 April 2008 - 03:33 PM

Very nice. One question though. Is the valve cover indented? If so the real one is not indented on a Ford 300 six. I work on a lot of them. Just wanted to let you know.


That's true for the Carbed version of the 6. However the fuel injected version is indeed indented to make clearance for the plenum and the throttle body. I can post pics later.

Thanks,

#4 James Flowers

James Flowers

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 1,062 posts
  • Location:Ohio
  • Full Name:James Flowers

Posted 20 April 2008 - 07:47 PM

All I see is red x's

#5 Ken Kitchen

Ken Kitchen

    MCM Friend

  • Members
  • PipPipPipPip
  • 102 posts
  • Location:Colorado Springs, CO

Posted 21 April 2008 - 01:06 AM

All I see is red x's


Strange I can still see the pics. Here's the link to my Fotki site so that you can see them.

Visit My Website