Jump to content


Here is my chopper project


  • You cannot reply to this topic
1 reply to this topic

#1 Irvin Arter Jr.

Irvin Arter Jr.

    MCM Avid Poster

  • Members
  • PipPipPipPipPip
  • 418 posts
  • Location:Clarks Summit, PA

Posted 29 September 2006 - 05:15 AM

OK here is my take. I am using the soft tail version as my base. I lowered and cut the rear fender. I de chromed the rear shock system and molded it into the base frame.

Posted Image

I am using the hard tail seat sanding off the logo and hinged it on the front and will make springs for the back of the seat. I sawed off the front forks so I could mold the frame.

Posted Image

I changed the angle of the front end and took off the fender and disk brake. I am using the drag bars with no risers. I lowered the front of the gas tank around 1/8" so it sits lower on the frame. That's it so far

Posted Image

Posted Image

enjoy!

#2 Matt T.

Matt T.

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 956 posts
  • Location:A-Town, Empire State
  • Full Name:Matthew T.

Posted 29 September 2006 - 05:53 AM

Looking good, Irvin! I enjoy seeing everyone's rendition of these kits.