Jump to content


metal axles never fit ?


  • You cannot reply to this topic
1 reply to this topic

#1 robdot

robdot

    MCM Regular

  • Members
  • PipPipPip
  • 55 posts
  • Location:ohio
  • Full Name:rob dotson

Posted 02 August 2011 - 04:16 AM

hi, iv recently built the lil mixer and the lil yeller, these came with metal axles that did not fit in the hubs, they also were not long enough. what i did was to cut them in half, heat them, insert them into each hub , dip them in glue and slide them into the axle sleeve assembly. am i missing something here? ) is there an easier way im supposed to do this? do the people who make these know the axles dont fit? surely they must, right?

#2 Harry P.

Harry P.

    MCM Ohana

  • Administrators
  • PipPipPipPipPipPip
  • 21,824 posts
  • Location:NW suburban Chicago
  • Full Name:A mere layman...

Posted 02 August 2011 - 04:44 AM

You also could have used brass rod cut to the correct length.