Posted 29 December 2011 - 12:24 AM
The start of trail an error's..
Posted 29 December 2011 - 12:31 AM
At this point, I knew I made a mistake an used the wrong kind of glue.. oops. So I waited too the elmers glue had set up an dried an I then took an removed the headliner back out much easier an with no mess either from glue.
I did make another temp on a 4th headliner an used spray glue which worked very very well.. I get photos today of that an post them soon as I can.
Posted 29 December 2011 - 10:12 AM
Posted 29 December 2011 - 06:49 PM
Posted 30 December 2011 - 09:58 AM
keep up the super work!!
farway model truck fleet
Posted 13 January 2012 - 02:08 PM
First few times with headliners.. mostly trail runs..
This time it was a go.
Started working with find the right blue color for on the rear doom lights covers.
Posted 13 January 2012 - 02:14 PM
The led light here is only hold into place, it's not even attach to anything yet, it's not in the correct spot either.
Here is the start of the first row of rear leafs in the making
Posted 13 January 2012 - 02:25 PM
Here is one of two from hub units, I took an held the rein hub unit to the tire on the inside an used a small drill bit (two of them, one small one for marking, 2nd one the size of the lug base) to mark the locations of each stud. Then I drilled out the hub unit just alittle to set the lugs just a hair down inside then I place a layer of masking of the outer face of the rim an open the holes up by using the excto blade. I then place well brush on some vasoline then I took an placed the lugs into the rim on the out side looking in. I then used epoxy on the resin hub only on the outer side just where the lugs would be in. I then place the hub onto the outer face of the rim over the lugs an left set for almost a day. I took an drilled out the lug holes in the rim after I had removed the hub with the lugs in so the rim would be easier mounting off an on.
Posted 13 January 2012 - 02:31 PM
With the rim on, to see on things look. I plan on redoing the two short lugs
Just a mock up like, to see how things will look
Up next is the rear suppen.
Posted 13 January 2012 - 02:34 PM
New mounting bracket in the works (white piece)
The top of the original kit piece mounting bracket.
Posted 13 January 2012 - 02:38 PM
The pass side one.
Edited by zerodude, 13 January 2012 - 02:40 PM.
Posted 13 January 2012 - 02:50 PM
This reply is for the reply for the one above that went hay wired on me (LOL).
Edited by zerodude, 13 January 2012 - 02:50 PM.
Posted 13 January 2012 - 05:12 PM
Posted 13 January 2012 - 08:34 PM
Posted 13 January 2012 - 10:17 PM
Posted 13 January 2012 - 11:00 PM
Now I have more photos of progress that I like to post..
As you know I'm working in the rear.
The top leaf