Jump to content


Atlas Transfer Case

As close as I could get

  • You cannot reply to this topic
3 replies to this topic

#1 steve7119

steve7119

    MCM Friend

  • Members
  • PipPipPipPip
  • 117 posts

Posted 29 January 2012 - 04:27 PM

I finally finished the transfer case. Tell me what you think. No U joints right now so whatever driveshaft is needed can be used. I did drill it all the way through to help get it lined up with the transmission. Didn't have any straight on photos of the output side, so I kinda guessed at what I think is the speedo attachment on the output housing
Posted Image
Posted Image
Posted Image

I followed the drawings I had so I made this a drivers side drop. Too late I figured out what I was making was the opposite of what I wanted. Figure to try to cast it and make the main case separate from the add on parts so I can make it a passenger side drop too.

#2 jeffs396

jeffs396

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 3,190 posts
  • Location:NE Ohio
  • Full Name:Jeff

Posted 29 January 2012 - 04:32 PM

Very cool Steve!

Looks accurate as far as I can see ( your pics are kinda blurry :( )

Are you going to reproduce these, or have a caster do it?

#3 steve7119

steve7119

    MCM Friend

  • Members
  • PipPipPipPip
  • 117 posts

Posted 29 January 2012 - 05:23 PM

Sorry about the blurry photos, I tried to get close enough to show the details but may camera won't focus as well up too close. I haven't had much luck with the casting. Not sure how to go about handing it off to a caster. I would love to have them available for everyone though.

#4 RyanSilva

RyanSilva

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 745 posts
  • Location:Massachusetts
  • Full Name:Ryan

Posted 29 January 2012 - 05:50 PM

Sent you a PM Steve, that looks great!