



Posted 18 February 2012 - 08:12 AM




Posted 18 February 2012 - 08:16 AM
Posted 18 February 2012 - 08:20 AM
Posted 18 February 2012 - 08:27 AM
Posted 18 February 2012 - 09:28 AM
Posted 18 February 2012 - 10:09 AM
Thanks...yes, I stripped off and filled in where necessary the original moldings, then made a new one from strip styrene. I measured the length, and then sanded the ends to a soft point. Once applied, the top half of the molding got a second styrene strip, much thinner glued on and all was then sanded again to round the edges. Once completed, it was covered with BMF.reat job Peter. I love the colors. How did you make the chrome spears at the front of the rear fender blisters...?? Are they plastic covered in BMF..?
Posted 18 February 2012 - 01:05 PM
Posted 18 February 2012 - 04:56 PM
Posted 18 February 2012 - 04:58 PM
Posted 18 February 2012 - 09:21 PM
Posted 18 February 2012 - 10:28 PM
Posted 03 March 2012 - 02:28 PM
Posted 03 March 2012 - 03:35 PM
Posted 03 March 2012 - 04:44 PM
Posted 03 March 2012 - 07:15 PM
Posted 03 March 2012 - 08:28 PM
Posted 03 March 2012 - 11:16 PM
Posted 04 March 2012 - 04:58 AM
Posted 04 March 2012 - 08:34 AM
Posted 06 March 2012 - 08:17 PM