Procharged Corvette Z06 - updated 4/10 Finished!
Posted 24 October 2012 - 04:33 PM
Mount in place on dash.
Light in place.
Posted 24 October 2012 - 04:52 PM
Those punch & die sets are great as, could not work without them. There is also a hex head set as well.
These kits from Jada are great. I wish they would make more. I did buy one of each when they were available.
Posted 25 October 2012 - 05:01 PM
Here are the uncut sleeves.
Trimmed front section.
Edited by shucky, 25 October 2012 - 05:03 PM.
Posted 25 October 2012 - 05:08 PM
One done, one to go.
Both rears done.
Thanks for watching and the kind comments.
Posted 26 October 2012 - 01:52 AM
Posted 26 October 2012 - 02:48 AM
and really like this build!
Posted 27 October 2012 - 05:20 AM
Posted 13 November 2012 - 05:21 PM
These are silver plated crimp tubes (size #1 .031) from the craft store. I'm using them for lug bolt covers. Gave them a quick coat of clear to preserve their finish.
And here I'm punching out some wheel center cap logo's from a decal sheet.
Posted 13 November 2012 - 05:26 PM
Next up is the brakes I borrowed from a Mr. Model wheel set. These will be getting attention next. More to come and thanks for the comments as always.
Posted 15 November 2012 - 06:59 AM
Posted 15 November 2012 - 06:33 PM
Posted 20 November 2012 - 03:16 PM
Brakes are simple but really nice pieces from Mr. Model. Calipers are painted metalizer brass with Tamiya clear yellow.
And the mock up's.