69 Yenko Camaro
Posted 07 August 2012 - 06:59 AM
Here are a few shots of my recently completed 69 Yenko Camaro. My intent was to do a box stock build but half way through I started adding some photo-etch detailing. This is why the engine wasn't wired as it was finished and installed in the chassis.
The paint is Alclad Pale Gold over white Tamiya primer with Tamiya TS-13 used as the gloss coat. Interior is Semi-gloss black. Flocking has been added to the flooring. Seats have a 2-tone black finish.
The vinyl top was created using the Model Car Garage kit.
BMF was used on all the chrome trim.
Comments welcome. Enjoy.
Posted 07 August 2012 - 11:35 AM
Posted 07 August 2012 - 12:36 PM
Posted 08 August 2012 - 01:43 AM
Posted 08 August 2012 - 11:19 AM
Posted 09 August 2012 - 06:58 AM
This was my first time using the kit and it was easy to use.
Posted 09 August 2012 - 07:06 AM
Posted 09 August 2012 - 08:56 AM
Boy that is really nice. Now if you could figger out a way to add the thin chrome trim around the bottom of the vinyl roof that would be a pretty cool finishing touch. Wish I knew how to accomplish that myself!
Terry, I was gonna use some thin silver hard wire as the trim. But I couldn't get the bends right and I was concerned about glueing it in place and not having the glue show.
There are a couple of local shows coming up and I will be entering it. I may try again after I show it.
Posted 09 August 2012 - 09:40 AM
Posted 09 August 2012 - 11:15 AM