Jump to content


Resin weld decals


  • You cannot reply to this topic
6 replies to this topic

#1 mikey

mikey

    MCM Friend

  • Members
  • PipPipPipPip
  • 184 posts
  • Location:VIRGINIA
  • Full Name:Michael Hensley

Posted 30 September 2012 - 03:40 AM

Iwas looking for rivet decals for a project and i found these as well.They are rearly cool looking but a little pricey.
Posted ImageHosted on Fotki
Posted ImageHosted on Fotki

#2 vypurr59

vypurr59

    MCM Avid Poster

  • Members
  • PipPipPipPipPip
  • 407 posts
  • Location:Cleveland Ohio USA
  • Full Name:Jeff Shorter

Posted 30 September 2012 - 04:09 AM

try looking up these through www.micromark.com
They have these in differant sizes, sheet is three times bigger and you get 2 sheets for less cost than the archer brand

#3 southpier

southpier

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 1,807 posts
  • Location:northeast coast
  • Full Name:joe smythe

Posted 30 September 2012 - 04:42 AM

Verlinden also has some part #2520 if you've gotten the courage to work with photoetch


http://www.verlinden...roducts_id=1916
http://www.verlinden...915763122838614

Edited by southpier, 30 September 2012 - 04:44 AM.


#4 mikey

mikey

    MCM Friend

  • Members
  • PipPipPipPip
  • 184 posts
  • Location:VIRGINIA
  • Full Name:Michael Hensley

Posted 30 September 2012 - 05:14 AM

Here is the link for the ARCHER decals.Micromark also sells a big sheet of rivet decals but no weld decals.If you scroll down the page you will see the weld beads section.The one in the picure is the starter set
http://www.archertra...etailsMain.html

Edited by mikey, 30 September 2012 - 05:16 AM.


#5 Ace-Garageguy

Ace-Garageguy

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 7,255 posts
  • Location:Down two, then left.
  • Full Name:Bill Engwer

Posted 30 September 2012 - 06:21 AM

Now that is seriously cool stuff. Thanks for the posts.

#6 Bernard Kron

Bernard Kron

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 2,706 posts
  • Location:Seattle, WA
  • Full Name:Bernard Kron

Posted 30 September 2012 - 07:10 AM

I've used Archer louver decals for quite some time and have had excellent results with them. I use their O-scale offerings to approximate 1/24-1/25th scale. http://www.archertra...om/AR88037.html

Edited by Bernard Kron, 30 September 2012 - 07:11 AM.


#7 Johan020

Johan020

    MCM Friend

  • Members
  • PipPipPipPip
  • 232 posts
  • Location:Amsterdam the Netherlands
  • Full Name:Johan

Posted 14 October 2012 - 03:33 AM

It seems like great stuff