Jump to content


Parts ID help needed *some new pics


  • You cannot reply to this topic
10 replies to this topic

#1 Ryan S.

Ryan S.

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 873 posts
  • Location:Alameda, CA
  • Full Name:Ryan Silva

Posted 29 October 2012 - 01:31 PM

Hi all,  I got the parts below as extras in any open box kit. Sorry the picture is a little far away but can anyone point me in the direction of which kit(s) these might be from. If needed, I'll get some closer shots up tomorrow. Thanks!

Posted Image

Edited by Ryan S., 30 October 2012 - 06:39 AM.


#2 Steve Milberry

Steve Milberry

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 2,219 posts
  • Location:Fredericton N.B. Canada

Posted 29 October 2012 - 02:11 PM

Some better pics would be good but the engine and syspension peices on the sprues look like it's from the AMT '70 Impala. The chrome looks to have the '67 or '68 Impala hubcaps and it looks like a '67 Impala dash.

SO,,, I'd say it's all from an AMT '67 Impala except the 2 smaller chrome trees. I don't recognise them.

Edited by Steve Milberry, 29 October 2012 - 02:11 PM.


#3 Ace-Garageguy

Ace-Garageguy

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 3,434 posts
  • Location:Down two, then left.
  • Full Name:Bill Engwer

Posted 29 October 2012 - 04:32 PM

The engine in the pic has a definite Chebby look, especially the water pump, but if it is, I'm guessing it's a big-block, judging from the even exhaust-port spacing of the stock exhaust manifold at the bottom center. Small-block Chebbies have the characteristic two-in-the-middle-together exhaust-port spacing. The valve covers on the upper chrome tree look like big Chebby also, from what I can see on my screen.

Do the referenced Impala kits have big blocks in them?

#4 Ryan S.

Ryan S.

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 873 posts
  • Location:Alameda, CA
  • Full Name:Ryan Silva

Posted 29 October 2012 - 04:53 PM

Thanks guys. I'll get some closer-up pictures tomorrow that will show all this stuff more clearly.

#5 Casey

Casey

    MCM Ohana

  • Moderator
  • PipPipPipPipPipPip
  • 7,998 posts
  • Location:Men. Falls, WI
  • Full Name:Casey Littmann

Posted 29 October 2012 - 04:53 PM

What does the flange in the upper left corner of the octagonal chrome sprue have cast into it?

#6 Ryan S.

Ryan S.

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 873 posts
  • Location:Alameda, CA
  • Full Name:Ryan Silva

Posted 29 October 2012 - 05:54 PM

What does the flange in the upper left corner of the octagonal chrome sprue have cast into it?


I'll have to look to see. That whole octagonal tree is a blower assembly. I'll see if there's kit numbers molded into it.

#7 mnwildpunk

mnwildpunk

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 590 posts
  • Location:Minneapolis
  • Full Name:Dave isle

Posted 29 October 2012 - 10:27 PM

Those seats look like the 65 el' camino seats for stock and drag versions but they probably came in other kits too. I agree it looks like a BBC. To me also. But I also think I see an E-body console

#8 Dan Helferich

Dan Helferich

    MCM Avid Poster

  • Members
  • PipPipPipPipPip
  • 297 posts
  • Location:Joliet Il.

Posted 30 October 2012 - 12:45 AM

I'm pretty sure the tree with the tri power manifold is also from the old AMT '67 Chevy kits. I think I built my convertible with those wheels. The small tree with the blower might be from a later issue AMT '29 Model A roadster.

#9 Ryan S.

Ryan S.

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 873 posts
  • Location:Alameda, CA
  • Full Name:Ryan Silva

Posted 30 October 2012 - 05:52 AM

Some closer pictures for your enjoyment. I was able to determine that some parts are from AMT #2345
Posted Image
These parts:
Posted Image

These all seem like they might be from the same kit, but not sure. The chrome sprue tree has the numbers 1727-5 on it, but despite some searching I couldn't find a kit match:
Posted Image
Posted Image
Posted Image
Posted Image

and these don't seem to match the others:
Posted Image

Thanks for the help on this, it'll be nice to know where these all came from! Cheers.

#10 Casey

Casey

    MCM Ohana

  • Moderator
  • PipPipPipPipPipPip
  • 7,998 posts
  • Location:Men. Falls, WI
  • Full Name:Casey Littmann

Posted 30 October 2012 - 10:16 AM

and these don't seem to match the others:
Posted Image

Thanks for the help on this, it'll be nice to know where these all came from! Cheers.



Are those twin headlights on the LH side?

#11 Ryan S.

Ryan S.

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 873 posts
  • Location:Alameda, CA
  • Full Name:Ryan Silva

Posted 30 October 2012 - 12:18 PM

They might be. They're semi hollow on the other side with a small raised post in each of the circular parts.