Jump to content


help with 1/12th tamiya Wolf WR1 steering


  • You cannot reply to this topic
1 reply to this topic

#1 smokwells

smokwells

    MCM Member

  • Members
  • PipPip
  • 5 posts
  • Location:HIGHLAND,NY
  • Full Name:STEPHEN WELLS

Posted 18 November 2012 - 04:04 AM

I am building a Tamiya 1/12th Wolf WR1. I have been thrilled with the quality of the kit so far. There is a place where the shaft from the steering wheel is supposed to connect to the steering rack. There are two thin shafts with a rubberized sleeve sliding over them to connect them. The shafts don't seem to go into the sleeve far enough. Should I try to drill the sleeve out some. Am i missing something? Any help would be appreciated.

#2 trogdor

trogdor

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 635 posts
  • Location:Georgia
  • Full Name:rick

Posted 18 November 2012 - 04:39 AM

Usually Tamiya kits are well engineered and everything fits properly especially the larger scales. I would re-check everything leading up to that step. Sorry I couldn't help much.