I’ll start with the frame. The original jig for the frame was a piece of 2X4 wood and then I taped some graph paper on it in order to keep the lines straight. I drilled a piece of brass to act as the fixture to hold the neck of the frame for the front-end/forks and everything else was built off of that. I eventually made a jig as I am possibly going to do three to four more of the bikes for the owner of the 1:1 bike.
The frame has sinced moprhed a little, but this is what it looked like after the first go-around and for the most part, it has the same geometry, etc., just some slight updates after looking at my reference material a littlecloser.
Edited by ScrappyJ, 23 November 2012 - 09:43 AM.