Is anyone making a plate system setup or fogger?
0
Nitrous
Started by Markemmonsracing, Dec 16 2012 12:01 PM
1 reply to this topic
#1
Markemmonsracing
-
- Members
-
- 7 posts
MCM Member
- Location:Loogootee in
- Full Name:Steven emmons
Posted 16 December 2012 - 12:01 PM
#2
Fat Brian
-
- Members
-
- 1,078 posts
MCM Ohana
- Location:Stanley, NC
- Full Name:Brian Croft
Posted 18 December 2012 - 04:49 PM
The plate is so simple to make I don't believe so. Usually the plates are about a half an inch thick or so right? I would just add a piece of sheet plastic to the bottom of whatever carb I'm using, a piece one millimeter thick would represent one scale inch in 1/25, and cut it to match the base plate of the carb. Then just run a wire to it for your NOS line.
