I previosly saw an article on how to apply heat to a warped bent-from-the-factory plastic car body.
Can anyone give me the info? Thanks.
1
Warped Plastic Car Body
Started by whale, Dec 17 2012 12:48 PM
Info on how to apply heat to using an oven? procedure how to fix car bent in box
3 replies to this topic
#1
whale
-
- Members
-
- 1 posts
Looker
- Location:675 Featherbed Ln. Garnet Valley, PA 19060
- Full Name:Woody Watkins
Posted 17 December 2012 - 12:48 PM
#2
Ace-Garageguy
-
- Members
-
- 3,372 posts
MCM Ohana
- Location:Down two, then left.
- Full Name:Bill Engwer
Posted 17 December 2012 - 01:06 PM
.....Very carefully.......
#3
scalenut
-
- Members
-
- 659 posts
MCM Ohana
- Location:Tennessee
- Full Name:Andy Hobbs
Posted 17 December 2012 - 03:22 PM
yep very very carefully or all at once it will go.... droop
#4
Fat Brian
-
- Members
-
- 1,078 posts
MCM Ohana
- Location:Stanley, NC
- Full Name:Brian Croft
Posted 18 December 2012 - 04:39 PM
Depending on where and how badly the body is warped you can use a hair dryer or dip the body in warm water. You just want to soften the plastic a bit, too much and it will deform.
