3 replies to this topic

[vc273]

Hi just thought i would upload a few pics of one of my build ups i have on the go. Have some pics elsewhere here but for those that didnt see them will post them aswell. Started with a real glue bomb pro stock kit that i was able to salvage and had a spare lindberg ramchargers dodge body lying around so thought i might match up the two. Here are some mock up photos. Cheers

[vc273]

Started work on the wheel tubs after getting rid of the paint as someone has hacked into them to get it to fit another body. Also have had to make up the rear bar section and the drivers cage as it only came with the side bars and the roof cage section. Not perfect but happy with my first attempt at bending and scratch building. Also had to extend the dash assembly now to finish off the cage. Cheers

[tubbs]

looking good Steve. love this kit and love big tired cars even more!! keep us posted. a little advice for your next cage, the bars in between the main bars can be smaller in diameter. makes it look more real and a little easier to work with. not the clearest picture.......

Attached Files

•  rear trunk area frame.jpg   53.68K   5 downloads

[vc273]

Just a little more work done. Have opened the trunk (boot here in australia ) and made a start on removing and installing a new trunk floor as the other was way too short and had been modified by previous owner. Also made a start on correcting some of the roll cage, bar work. Thanks for the advise al better to fix now than waiting till its painted. Have made a start on engine assembly but not happy with induction manifold set-up and may change latter on. Cheers and thanks for looking.