10 replies to this topic

[migace]

I came across this when I was looking at diecast. Anyone hear of this or know its origins? Is this an AMT tool? 

 

http://www.diecastdi...ctCode=LND73050

 

 

[Joe Handley]

It isn't, but the body and interior is pretty close IIRC.

[mikemopar70]

Actually it's a Testor's 1/24th scale pick-up, released about ten years ago!!

 

It was red on the box...and based on a rock band actual vehicle!!

 

It has white stripes everywhere on the body..

 

It was custom version only, just like the Lindberg one.    

[Joe Handley]

Yup, it was penned by Chip Foose and built by Hot Rods by Boyd for Eddie Van Halen...........IIRC, The model looked about right for Foose's original artwork too

Almost forgot,

http://blog.hemmings...uler-sightings/

Edited by Joe Handley, 16 January 2013 - 01:49 PM.

[tooltas]

its a cool kit nice lt1 or 4  all c4 vette under

[Joe Handley]

its a cool kit nice lt1 or 4  all c4 vette under

 

I don't remember on the 1/1, I think the kit is just a curbside or has an LT1 in it as well as the C4's IRS, I can't remember for sure.   I think the rest is pretty much all C-1500, just can't remember what all was done to the front end to make it what it was though.

[gray07]

The real one is also on the front cover of i think Hot Rod magazine, maybe Carcraft

[Edsel-Dan]

I think 2 versions were offered of the "Boyd's Hauler"

Full glue & Curbside. The Curbside may even have been a Slammer with black-out windows and NO interior.

 

I did not buy any then as I was not interested in the non-stock only build

 

I believe they did the same on the Chezoom "57 Chevy" kit too

Edited by Edsel-Dan, 16 January 2013 - 07:32 PM.

[AirForceOne]

I built the Testors kit some time in the 90s as a kid.  It was the full detail model, and it was a very good kit.  Good to see it coming out again.

[Bruce Poage]

I picked up a Boyd;s Hauler opened kit at a garage sale.  I see it is a Testors kit. It loks cool.  Does anyone have any insight as to possible problems with this kit?  Thanks.

[G Holding]

I have 3 of the Testors / Boyds kits.......A lot of work, and I have had lots of warped parts.....All the frames have been warped!