What happened to Dencon Resin is he coming back.
Can anyone tell me where I can get a Dencon Ford 337 Flathead "Rouge" Engine, please.
Edited by Frank, 13 February 2013 - 07:25 PM.
1
337 ford engine
Started by Frank, Jan 24 2013 06:11 PM
6 replies to this topic
#2
Frank
-
- Members
-
- 208 posts
MCM Friend
- Location:Australia
Posted 13 February 2013 - 07:27 PM
What happened to Dencon Resin is he coming back.
Can anyone tell me where I can get a Dencon Ford 337 Flathead "Rouge" Engine, please.
bump
#3
Casey
-
- Moderator
-
- 8,137 posts
MCM Ohana
- Location:Men. Falls, WI
- Full Name:Casey Littmann
Posted 14 February 2013 - 06:13 AM
You'll probably have to wait for one to pop up on eBay, Frank, or put an ad in the Wanted section here.
#4
dimaxion
-
- Members
-
- 840 posts
MCM Ohana
- Location:NE Indiana
- Full Name:John JR. Landgraver
Posted 14 February 2013 - 06:46 AM
I did contact Matt here on this site . = no answer ? Thanx ..
#5
Ken Kitchen
-
- Members
-
- 103 posts
MCM Friend
- Location:Colorado Springs, CO
Posted 14 February 2013 - 02:00 PM
What happened to Dencon Resin is he coming back.
Can anyone tell me where I can get a Dencon Ford 337 Flathead "Rouge" Engine, please.
Is this the Flathead V8 that was in the big trucks and Lincolns? If so I might be able to help. Contact me at kitchen_table_resins@yahoo.com
#6
Eshaver
-
- Members
-
- 3,756 posts
MCM Ohana
- Location:Richmond Virginia for now
- Full Name:Ed Shaver
Posted 16 February 2013 - 10:26 AM
Is this the Flathead V8 that was in the big trucks and Lincolns? If so I might be able to help. Contact me at kitchen_table_resins@yahoo.com
Yes ken, that's the Ford "Big Job " engine .
#7
Ken Kitchen
-
- Members
-
- 103 posts
MCM Friend
- Location:Colorado Springs, CO
Posted 16 February 2013 - 11:02 AM
Yes ken, that's the Ford "Big Job " engine .
Ed,
Thanks for the reply. Matt and I by purest of coincidence both produced a master of this engine at nearly the same time. Since he was first out of the gate I didn't push mine. But if he's no longer producing them I would consider offering mine again.
Ken
