Jump to content


Q on Hudson steering linkage


  • You cannot reply to this topic
1 reply to this topic

#1 Jon Cole

Jon Cole

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 3,459 posts
  • Location:NH, USA
  • Full Name:Jon... although my parents used to call me "KNOCK IT OFF!"

Posted 14 April 2013 - 10:35 AM

I have attempted to modify the tie rod on the Hudson for posable steering. There is a piece in the middle that must swivel. Even though I had the engine in place, it popped free, so I removed the engine. I didn't have the block glued in well. Do you think the engine will trap that swivel in place if I glue the engine in?

 

HUDSONdetail01.jpg



#2 vypurr59

vypurr59

    MCM Avid Poster

  • Members
  • PipPipPipPipPip
  • 411 posts
  • Location:Cleveland Ohio USA
  • Full Name:Jeff Shorter

Posted 14 April 2013 - 05:04 PM

Depends if the engine sets on it or there is a space. Take up the space with a small scrap piece of clear acetate or plastic, so being there it should remain invisible when looking.