It is, its making me crazy
First I ordered the red seat-belts (second post), when received I found out they are to short because the seat is on a frame.
Ok,that can happen so I ordered others from Hobby Design.
Now I got the next challenge
First you have cut piece A than bend the corners at the dotted line, so far so good
Next thing is cut piece B and bend the ends, then move it in the tiny holes at C in piece A....... this does not fit, even without bending it does not fit. My smallest drill is 0,5mm and this is even bigger than the bend corner part.
Then I found the other problem, the belts does not fit the clips D.... the belts are to wide, I tried sanding them but its very difficult to hold them
I seriously don't understand why they sell this stuff if it doesn't fit at all Might skip this idea and use the belts for the another detail in the truck.
Edited by Dinky, 18 October 2013 - 12:46 AM.