its BUFFALO TIME 1/10 mostly scratch AKA BONE CRUSHER
Posted 11 October 2013 - 01:48 PM
next is the windows
Posted 14 October 2013 - 10:15 AM
Posted 15 October 2013 - 08:15 AM
Posted 16 October 2013 - 12:29 PM
Your work is incredible... I hope you will post a video of that truck moving outdoor when finished.
Posted 16 October 2013 - 12:40 PM
Posted 16 October 2013 - 01:18 PM
Edited by midengineaddict, 16 October 2013 - 02:45 PM.
Posted 17 October 2013 - 12:45 PM
Posted 21 October 2013 - 11:55 AM
so I had one of those 3 steps back , the airbrake containers under the axle were out of scale. must of forgot a number. anyway I had to make them 4 mm bigger,
next ive added backers to the axles for the brakes . you can see them here looking at the axle to the drum
I finally finisehed installing all the mud flap mounts , I bought some 1/16 thick 12x12 inch rubber sheet. it works perfect
im getting close of finishing the lower hull and chassis , almost ready for paint
Posted 22 October 2013 - 11:46 AM
Posted 23 October 2013 - 10:41 AM
I started on the forward compartment
I received in my sound and light kit. this all should fit in the engine compartment, the battery will go under the floor boards
I scaled out the seats and seats mounts and there dead on, on difference in the seats is the backer is lot higher, but the width is the same
after installing the seat something look off. I lost 8mm in between seat, not sure where, I look at some 1:1 interior, man! these guys cant even stand up in side without crouching, really tight inside, so maybe im not that far off .
Posted 23 October 2013 - 11:25 AM
man your updates are so good I can wait to see the next's
Posted 23 October 2013 - 01:48 PM
Always looking forward to your updates!
This is some outstanding work.
thanks everybody, shes moving along pretty quickly