Jump to content


Mufflers


  • You cannot reply to this topic
4 replies to this topic

#1 The Moparian

The Moparian

    MCM Regular

  • Members
  • PipPipPip
  • 52 posts
  • Location:Binghamton, New York
  • Full Name:Tony Dattoria

Posted 03 June 2014 - 08:30 AM

I'm working on making my own exhaust for a project and want to get some resin mufflers. The car is gonna have a 3 inch exhaust using 3mm solder. Does anyone know of any mufflers that are large enough? I don't want the pipes larger than the mufflers themselves. Thanks

#2 astroracer

astroracer

    MCM Friend

  • Members
  • PipPipPipPip
  • 142 posts
  • Location:Mid-Michigan
  • Full Name:Mark

Posted 04 June 2014 - 05:49 AM

Doesn't matter what you get or use. If they are too small cut the offending appendages off and drill a hole for your solder to glue into. Once they are glued wrap a piece of .010 sheet plastic around the solder to make the new slip joint.

Mark



#3 The Moparian

The Moparian

    MCM Regular

  • Members
  • PipPipPip
  • 52 posts
  • Location:Binghamton, New York
  • Full Name:Tony Dattoria

Posted 04 June 2014 - 06:36 AM

That's a great idea. Thanks!

#4 freakshow12

freakshow12

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 1,718 posts
  • Location:melfort saskatchewan canada
  • Full Name:fred mckee

Posted 04 June 2014 - 07:48 AM

I use quite a few of the mufflers from the 70 super bee pro street kit. One strip of styrene down the middle and they look like a blow master. Err flowmaster

#5 MeatMan

MeatMan

    MCM Friend

  • Members
  • PipPipPipPip
  • 162 posts
  • Location:Shaker Heights, Ohio
  • Full Name:Dennis

Posted 04 June 2014 - 11:19 AM

VGC Resins has a Flowmaster type with no ends on it so you make your own.  Its under the "Drivetrain" section for some odd reason.  You can email him and he'll check the sizing for you.