Jump to content


Camaro wagon


  • You cannot reply to this topic
1 reply to this topic

#1 Bige37

Bige37

    MCM Regular

  • Members
  • PipPipPip
  • 64 posts
  • Location:Westfield, Wisconsin
  • Full Name:Eric A Bethke

Posted 01 July 2014 - 11:15 AM

So I recently purchased a jimmy flinstone resin camaro wagon body I'm doing some research and was wondering if anyone else has tried to build one of these amd if ao any auggestions? I know I have to use a 2006 camaro kit but when dry fitting the interior I noticed the rear half doesn't fill the void and is slightly angled downwards. Am I to use sheet styrene to make up the difference and also the wheel wells don't fit properly thereis a 2mm gap between well and the rear corner of the body! I went ahead and built the camaro itself and was thinking if trying to use a 2010 or newer camaro doner kit if not ill get another 06 camaro! Again if anyone has Reyes this and has any suggestions let me know and if so pics of yours might help me out to

#2 mnwildpunk

mnwildpunk

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 2,084 posts
  • Location:Minneapolis
  • Full Name:Dave isle

Posted 01 July 2014 - 11:28 AM

Flintstones kits are a bit to be dsired but when done right look nice