Jump to content


Luberfiner hoses, where do they go


  • You cannot reply to this topic
2 replies to this topic

#1 Petetrucker07

Petetrucker07

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 3,392 posts
  • Location:Hesperia, Ca
  • Full Name:Clayton Scheiber

Posted 02 August 2014 - 02:44 PM

Where do the hoses go from the luberfiner can on the side of cab go? How are they properly ran from the can to wherever they go?

#2 JARRNO88

JARRNO88

    MCM Regular

  • Members
  • PipPipPip
  • 60 posts
  • Location:Marathon, New York
  • Full Name:Keith D. Danby

Posted 02 August 2014 - 03:17 PM

 Hi Clayton,

           I  asked the same question a while back and here is the information that I printed out the same as it was given to me.

  Luberfiners are bypass oil filters.  The inlet hose is connected to a pressure point on the engine (usually on the oil filter mount)

  and the return hose is connected to the crankcase ( usually the side of the engine block just above the oil pan rail ) These

  connections would be pretty much the same regardless of the engine brand.  As for the Luberfiner itself, the center hose is the

 return hose and the hose that is off center is the inlet.  ( A Luberfiner can be mounted any direction but must be serviceable)

     I hope this helps you out, Keith 



#3 Petetrucker07

Petetrucker07

    MCM Ohana

  • Members
  • PipPipPipPipPipPip
  • 3,392 posts
  • Location:Hesperia, Ca
  • Full Name:Clayton Scheiber

Posted 02 August 2014 - 03:40 PM

Thats what i needed, thanks Keith. Even if i dont get it right, itll be close enough.

I was lookin at on the side of the cab and decided it needed hoses, time to do some detailing that ive never done before.