Jump to content

  2. > Viewing Profile: Posts: Brian_B

Brian_B

Member Since 18 Aug 2012
Offline Last Active Oct 10 2012 10:15 PM
-----

Posts I've Made

In Topic: THE "ROY MUNSON" 72 OLDSMOBILE CONVERTIBLE

08 October 2012 - 11:27 PM

Are you going to build the 442 from Woody Harrelsons other movie too? "play it to the bone" with antonio banderas had this one:

In Topic: Work/Cutting table

20 September 2012 - 11:03 AM

mine is an exacto brand that was on sale at wal mart for $5. You can get them about any size and cost you want. LOL

In Topic: Neat way to decant paint with condiment cups

19 September 2012 - 11:36 AM

Most any hobby shop with a good RC Airplane section should have these polypropylene (cloudy translucent plastic that is impervious to just about any paint or solvent we modelers are likely to use) in bulk packs. Chances are the polybag package header will say either K&B or Hobbico on them. Also check craft stores--these get used a lot in mixing clear polyester resin for clear resin cast craft projects. They're not very expensive either. and are the same little cups that hospitals use to bring pills to your bedside.

Art


Ahh,,,just as I suspected. None within 2 hours drive of here. Thanks.

In Topic: Right size half round stock for 1/16 ?

19 September 2012 - 09:37 AM

i know nothing about this, but I just looked at tower hobbies (where I bought some evergreen). They show half round in: .100, .125, .80, .60, and .40.

Pleats as in seat material? You could get a thin corrugated sheet in the right size and cut a sheet to fit. Its for dioramas, but there is a tutorial using it on seats somewhere I saw online.

In Topic: Great Traders List

18 September 2012 - 12:47 PM

Would like to add my first trade on the board.

bill_rules----Bill Lumbert


He really helped me out, excellent packaging, and shipping.


  1. Model Cars Magazine Forum
  2. > Viewing Profile: Posts: Brian_B
  3. Board Rules and Guidelines