Can anyone tell me what it takes to keep a Paasche H series airbrush from clogging about ten seconds into spraying ? Im shooting Vallejo Model Air paint. Ive the past two attempts even tried thinning the paint a tiny little bit with rubbing alcohol hoping to cure the problem but the same happened. Ill take the bottom fed cup off, take the tip and needle off, clean both, put it back on, start spraying again and it works like it should for about ten seconds and then back to the same clogging. I clean the needle tip with a qtip or rag, nothing. Starting to get very frustrating. Any advice would be greatly appreciated. Hoping Donn Yost will chime in here as this is his brush of choice I believe.
Also with the different 1, 3, and 5 tips. Do you need a different needle for each or does the needle that comes with the kit work for all three tips ? Ive only ever used the 3 tip because thats what was on the airbrush when I received it and couldnt seem to figure out how to get either of the other two tips on. Thanks in advance. (So frustrated Im about to send my Badger Patriot 105 back to Badger, get it fixed and go back to using that one ).