Jump to content


GlueTube

Member Since 28 Dec 2012
Offline Last Active Jul 08 2014 05:12 PM
-----

Posts I've Made

In Topic: Newly reissued Revell BRE Datsun 510 Racecar kit

06 July 2014 - 04:41 PM

Yup. 13 inch wheel diameter. Raced against a few of the "BRE" clones in my club racing days.

 

Regards

 

Brian Kroon


In Topic: '69 Owens Corning Corvette

06 July 2014 - 04:35 PM

Good job. Especially setting the roll bar hoop back into the body. Good eye for the details!

 

Regards

Brian Kroon


In Topic: Digital version of model cars magazine

06 July 2014 - 04:28 PM

Gents,

 

Count me in on the digital side. Adobe Acrobat......then I print the pages I want. I am not a subscriber as I just cannot justify in my own mind the the "foreign subcriber rates" for mail. I would be happy to pay for the sub...not the outrageous shipping cost.

 

Regards

Brian


In Topic: How Many Of You Guys Live In Canada

06 July 2014 - 04:21 PM

Gents,

 

This should be called the Canadian Zombie Thread. Anyone check the start date...

 

anyhoo  I'm in. Edmonton Alberta

 

Regards

Brian Kroon


In Topic: For any of you that still believe 3-D printing is a far-off dream...

06 July 2014 - 04:16 PM

Impressive to say the least, but was it output on a $45,000.00 machine or a $2500.00 machine? I have out put samples from many machine producers as I thought I wanted one and went serously shopping for one. As of May of this year, NONE of the consumer based machines had the fidelity required for modeling.

 

For those that doubt my claim all I can say is go shopping and get out put samples. Will the fideiity get there? Sure, but I doubt it will be soon. Years away. The best thing is to use a serivce that can output your files on an expensive printer.

 

Regards

Brian Kroon