Jump to content


deucebuilder

Member Since 16 Sep 2007
Offline Last Active Dec 26 2007 10:21 PM
-----

Posts I've Made

In Topic: Latest Project

25 December 2007 - 01:19 AM

Great looking Deuce their Matt. I'll have to try yhat flip-nose. Yours too Al. By the way Al, where did you get a 1/8th scale 409. Or better yet, where can I get one.
Thanks,
REX


Wheredid you get that track nose from, as I am thonking along the same lines myself.

In Topic: 1957 Chevy Bel Air

25 November 2007 - 09:15 PM

It looks you're going to have a cool build

In Topic: Butchered Pickup

19 November 2007 - 09:14 PM

Way to go hermit, the pick up looks cool.

In Topic: Opening Doors On The Big Deuce?

04 November 2007 - 12:53 AM

The tip about aligning the door hinges is very important. If anything is out of alignment the doors won't work.

Here's what I did: I drilled out the hinge arms to accept a straight pin. Then I taped the door panel in place, and carefully glued the hinge arms into their respective slots in the door and body. Before the glue dried I simply slipped a straight pin into the upper and lower hinge, which assured that the hinges would dry in perfect alignment.

After everything was painted, I used the same pins as the final hinge pins (just snipped them off at the correct length and dropped them into the hole).


Thanks for the tip, I hope to open the doors on one of my deuce, when I start building again.

In Topic: Ford 32 street rod

15 October 2007 - 10:07 AM

nice work Mario. I am hopefully going to start building again soon.