Jump to content


Agnaldo

Member Since 17 Dec 2008
Offline Last Active Feb 16 2013 09:36 AM
-----

Posts I've Made

In Topic: 71 Cuda, all aluminum hemi

16 February 2013 - 08:23 AM

Fantastic, very, very beautiful. From an incredible realism. You have much skill with the lathe, congratulations.

 

Hugs


In Topic: 1955 Chevy Cameo Street Machine (re-post)

16 February 2013 - 08:01 AM

Great job man, perfect. Congratulations.

 

Hugs.


In Topic: 1963 Ford Galaxie 500 XL

16 February 2013 - 07:36 AM

Great job man, congratulations.

 

Hugs


In Topic: '53 Ford Victoria Oldschool

09 September 2012 - 08:20 AM

Photos from the application of bare metal, because this step already finalized. I liked the result, despite flaws in the pictures are not very evident, but finalized and liked. The problem I believe is the knife I use, because I have no stylus, and even with a new blade just for that, it means chewing bare, instead of cutting just right.

Very bare metal to apply, same too. Never make a car with so many beads.

Posted Image

Posted Image

Posted Image

Posted Image

Posted Image

I made one more detail after these photos. The best so far. To better

Posted Image

Ta near completion. Please tips, comments and suggestions as always, welcome and necessary.

Hugs for all.

In Topic: '53 Ford Victoria Oldschool

09 September 2012 - 08:16 AM

Inside the door handles made with bare metal. It was not legal, but it was my first experience with this material. Not much enjoyed not the result, but should be better than masking to paint right. I applied the powder as I had seen before, and of course, as I had problems starting node assembly, was a small gap close to the floor and the wall cuts focus, but I'll try to improve this tomorrow.
Everything here was applied in semi gloss or satin varnish.

Posted Image

Posted Image

Posted Image

Posted Image

Posted Image

Posted Image

Posted Image

Posted Image

Posted Image

Details of the start of fireproof wall.


Posted Image