Jump to content


Fewski

Member Since 26 Jan 2009
Offline Last Active Oct 02 2012 06:51 PM
-----

Posts I've Made

In Topic: Work/Cutting table

20 September 2012 - 11:19 AM

Thanks all

In Topic: Couple newbie questions..

08 December 2011 - 02:57 PM

Thanks guys for the reply.. it all helps. Finding more information every search.

I'm thinking of using graphing paper to lay down under the frame to help make a chassis jig... what is the best to attach the graphing paper to so I can attach nail wood into for the jig? I'm guessing a piece of wood would work, but I'm seeing some nice looking platforms other people have used in the past but unsure what material it is?

Thanks again

In Topic: Couple newbie questions..

08 December 2011 - 01:17 PM

From what I can see, the styrene companies are located overseas. 10" rods wouldn't be to bad the more I think about it.. chances are slim I would use a full rod anyways.

I'm thinking the plastic will be easier to work with? Not to mention a lot cheaper? Correct me if I'm wrong.. I would love to do it with brass tubing, but cost and ease are my primary concerns.

Looking at building a Daytona Prototype. Love those cars. Not sure how it'll work out since there are no kits, but I'm going to give it a hell of a shot.