Search the Community
Showing results for tags '3dprinting'.
Morning guys It's an old Revell kit 1:24 of another iconic car, the BMW 507 cabriolet. I bought it 1 or 2 years ago for cheap on EBay This car was supposed to be the direct competitor and rival of the Mercedes 300SL Gullwing, but never really broke through. Only 252 examples were built and BMW lost a lot of money with this production. Elvis Presley bought a pearl-white one during his military service in Germany and brought it back to the United States, where he quickly had it repainted in red, tired of regularly seeing the lipstick marks left by his fanatic admirers on its beautiful bodywork.... funny isn't t ? His car had next a very complicated story and was abandoned during 30 years by his last owner. Fortunately, it was found in 2014 by an automotive journalist in Jack Castor’s pumpkin warehouse near San Francisco, but in a ad state. After many discussions, the car came back in Munich, Germany, where BMW Group Classic finally received in 2016 permission to restore it to its original condition. I've started this one early July and I'm progressing slowly since it will be widely modified to get the trunk, the doors , the fuel flap openable but also because The kit depicts a BMW 507 series 1, while Elvis's one was a Series 2. So a lot of surgery is needed ! What's in the box ?: A lot of clusters (not sure of word is appropriate, "sprues" would be better ? ), with very well done and nicely detailed parts, except for the chrome parts one. Clear parts are just good, a lot of burrs, but no distortion through them. Obviously, this kit is at its time's standards (1991) and the quality can't rivalise with Tamiya's one, but is far better than the MB 300 SLR Mille Miglia one I've decided to paint it Pearl White, as it was when Elvis bought it. As this car has been recently restored, a lot of videos and photos or press articles is available, what will allow to improve the model by correcting any errors and adding as much details as possible in this scale So, let's go for a new adventure
I designed this 1/25th scale Go Kart engine in SolidWorks and had it printed by Fractional. The crankcase with pull starter was grown as one piece. The cylinder/head and carb were grown as another. The chain, sprockets and clutch are one piece and the exhaust is one more. I machined the tank, cap and velocity stack from alumminum. Also grown... Two piece Go Kart wheels and treaded tires (with custom decals).