Search the Community
Showing results for tags 'rockys rat'.
Found 2 results
I built this car about a year and a half ago, but it's never been an MCM WIP, or shown in the Under Glass section. A couple of MCM regulars asked me if I had a few more pictures to share, so I thought that a mini WIP would provide them with some added pics and info on the car. So, to begin, I started with Revell's excellent 1:25th 40 Ford kit. The first order of business was to give it a hair cut. I sliced some Tamiya 6mm tape in half to create some ~3mm strips. These were used to remove a consistent scale 3" from the roof pillars. After adding some length back into the roof panel, it looked like the fit was close enough to continue.Notice how the B pillars were removed just below the drip rail in a "T" section. This will allow the pillar to be aligned with the lower pillar in the fore-aft direction. Still no putty yet. At this point the plastic used to lengthen the roof panel was filed down and primed. The roof was then glued in place with some liquid styrene cement. Considering I haven't reached to putty stage yet, the roof was looking pretty good. Still no putty yet. A layer of sheet styrene was added at the C pillar to provide enough material to level the roof panel with the stub on the body.
Here's some pics of one I built a year or so ago, but just finished the WIP today. Revell 40 Ford business coupe. Chopped top, reworked trunk area, reshaped grille shell and headlight buckets. The interior panels scratch built to give the look of inner structural panels. Lots of scratch built details on engine, interior and chassis. WIP: http://www.modelcarsmag.com/forums/index.php?showtopic=49399&st=0