muddragger92 Posted September 2, 2015 Share Posted September 2, 2015 How big should the gap be between 4-link brackets on the rearend? Quote Link to comment Share on other sites More sharing options...
Jantrix Posted September 2, 2015 Share Posted September 2, 2015 Your best bet is to find those measurements on a 1:1 four link set up, and then change it to scale. 1 inch in 1:1 = 1 millimeter in 1/25 Quote Link to comment Share on other sites More sharing options...
futurattraction Posted September 2, 2015 Share Posted September 2, 2015 In 1:1, it's going to depend on the dimensions of the hardware being used to join the suspension to the brackets. 4-link brackets are going to user a larger size rod end than those used on the front suspension, say, of the same car. I'm sure others will chime in with more info. Quote Link to comment Share on other sites More sharing options...
muddragger92 Posted September 2, 2015 Author Share Posted September 2, 2015 Thanks guy for all your input I just went out an messured the ones on my mud truck an just scaled it down Quote Link to comment Share on other sites More sharing options...
socal76 Posted September 3, 2015 Share Posted September 3, 2015 I just got my photo-etched ones from Scott at futurattaction. Picked them up at the Kansas City show and you won't be disappointed. Quote Link to comment Share on other sites More sharing options...
muddragger92 Posted September 4, 2015 Author Share Posted September 4, 2015 Thts where I got mine from I love the work its amazing an everything is spot on. I got my rearend an my link from him an im planin on gettin alot more from him. Quote Link to comment Share on other sites More sharing options...
Quick GMC Posted September 5, 2015 Share Posted September 5, 2015 i just ordered 1 of each of the Futurattraction 4 links. They are very nice. Be carefull when peeling off the backing though, it can be a little tough, I nearly bent one beyond repair. Might have had something to do with it being in a metal mail box and 119 degrees Quote Link to comment Share on other sites More sharing options...
futurattraction Posted September 7, 2015 Share Posted September 7, 2015 (edited) Cameron - a good way of removing the backing without risking damage to the PE parts is to place the backing rubber and all in acetone until it separates by itself. You'll need to soak it in acetone to remove the purple/blue film anyway. If left long enough, everything will come apart on its own without physically separating it. This is especially important on lighter gauge PE or if there are etch lines intended for bending in a certain location. This suggestion is also on my website in the Tips 'n Tricks section, in case you missed it. Edited September 14, 2015 by futurattraction Quote Link to comment Share on other sites More sharing options...
Quick GMC Posted September 14, 2015 Share Posted September 14, 2015 Thank you, I will do that next time Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.